Search Results

Q: Why is the compass not detected when the GPS and compass are connected to the side UART4 port? A: INAV firmware requires the compass to be connected to a designated I2C bus. To provide the best compatibility with different GPS modules, the AeroEgg H743 flig...

Introduction: This article explains only how to flash arbitrary firmware through DFU. Upgrade procedures specific to certain firmware, such as updating ArduPilot through the bootloader, are outside its scope. DFU is boot code permanently embedded in the flight...

Product Overview This product is a general-purpose GNSS and compass module compatible with most mainstream flight controllers and open-source firmware. Designed as an alternative to the BZ-251 series GNSS modules, it can acquire more than 30 satellites in appr...

INAV 8.0 Configurator download https://github.com/iNavFlight/inav-configurator/releases/tag/8.0.0 Firmware download https://github.com/iNavFlight/inav/releases AeroEgg Technology mirror (use this if GitHub downloads are unavailable) https://download.aeroeggtec...

Q: Why does the flight controller fail to detect my GPS when it is connected to UART4? A: Ensure that all serial ports below UART4 are not configured for the GPS protocol (for example, UART2), and that UART4 is configured for the GPS protocol. AP firmware sear...

TODO

Flight Controller Board - Front Flight Controller Board - Rear ESC Board

ArduPilot firmware is available at https://download.aeroeggtech.com/?dir=ArduPilot%E5%9B%BA%E4%BB%B6/AET-H743-CH4 BetaFlight firmware is available at https://download.aeroeggtech.com/?dir=BetaFlight%E5%9B%BA%E4%BB%B6/AET-H743-CH4