AET-H743-AIR Flight Controller AGC Configuration and Tuning Guide
AET-H743air Manual
Rapid Parameter Configuration with AGC
The following section explains how to use AGC for rapid parameter configuration. After you unders...
H743AIR Procedure for Configuring a Y3 VTOL Fixed-Wing Aircraft with the AGC Ground Station
Installation After connecting the devices to the flight controller, configure the corresponding ...
Device Wiring, Arming Configuration, and Flight Modes
In this example, the receiver is connected to port 4, so the corresponding port must be configure...
Installation and Calibration
Install the flight controller and GPS correctly on the airframe before performing compass calibra...
Tilt Servo Precautions
Basic Setup - Fixed-Wing Y3 VTOL Parameter Description
The Following Content Is an AGC Manual Configuration and Tuning Tutorial
Chapter 1: VTOL Setup
VTOL Setup 3.1 Initial VTOL Configuration and Tuning Flight Controller Settings β Quick Settings ...
Chapter 2: Channel Configuration and Pre-Arm Check Configuration
Common Configuration and Tuning When configuring an aircraft, parameters often need to be changed...
Chapter 3: Channel Configuration, Servo Setup and Checks, and ESC Calibration
Output Settings Channel Configuration Open the Output page in AGC to configure each flight contro...
Chapter 4: VTOL Tilt, Multirotor, and Return Parameters
You can query the AI in AGC for information about all parameters listed below. 6. VTOL Parameters...
Chapter 5: Airspeed Sensor Configuration
First-Flight Setup After Installing the Airspeed Sensor 1.ARSPD_TYPE = 1 (other parameters become...
Chapter 6: VTOL Takeoff, Transition, and Fixed-Wing Testing
.VTOL Takeoff Test 8.1 Multirotor Feedback Logic Check Wait until the flight controller completes...