Recently Updated Pages
H743-AIR PRO
AET 4G Positioning Telemetry Link User Guide
Side charging indicators: Each green segment represents 25% battery capacity. The indicator is re...
v2.0 Manual
Main Controller and Power Board Wiring Diagrams
Flight controller tutorial supplement: T/R port identification, receiver wiring, and serial-port ...
Enabling RID with the AeroEgg AGC Ground Station
Initial Configuration 1.1 Flash flight controller firmware that supports RID. Firmware download i...
Initial Configuration: Enable AeroEgg Technology RID Using MissionPianner and AeroEgg AGC
How to Use the RID Module On the “Flight Data” screen, right-click the location shown in the imag...
6. Release Notes
3. Functions and Configuration
2. Interface Description
2.1. Front Interfaces
1. Safety Precautions
Do not connect or disconnect USB devices during flight. Doing so can cause control latency, stutt...
Table of Contents
Chapter 6: VTOL Takeoff, Transition, and Fixed-Wing Testing
.VTOL Takeoff Test 8.1 Multirotor Feedback Logic Check Wait until the flight controller completes...
Chapter 5: Airspeed Sensor Configuration
First-Flight Setup After Installing the Airspeed Sensor 1.ARSPD_TYPE = 1 (other parameters become...
Chapter 4: VTOL Tilt, Multirotor, and Return Parameters
You can query the AI in AGC for information about all parameters listed below. 6. VTOL Parameters...
Chapter 3: Channel Configuration, Servo Setup and Checks, and ESC Calibration
Output Settings Channel Configuration Open the Output page in AGC to configure each flight contro...
Chapter 2: Channel Configuration and Pre-Arm Check Configuration
Common Configuration and Tuning When configuring an aircraft, parameters often need to be changed...
Chapter 1: VTOL Setup
VTOL Setup 3.1 Initial VTOL Configuration and Tuning Flight Controller Settings → Quick Settings ...
Rapid Parameter Configuration with AGC
The following section explains how to use AGC for rapid parameter configuration. After you unders...