Recently Updated Pages
Chapter 4: Receiver, GPS, Video Link, Bluetooth, and Telemetry Configuration
Receiver configuration: When using an SBUS receiver (such as Tiandifei WBUS, RadioLink, or Futaba...
Chapter 3: Basic Configuration and Tuning - Six-Position Calibration, Compass, Servo, and Motor Setup
Section 1: Connect the Ground Station and Reset Default Parameters. Open the MissionPlanner confi...
Chapter 2: Flight Controller Wiring
The wiring diagram for the AeroEgg AET F405A WING flight controller is shown below: Warning: The...
Chapter 1: Flashing Flight Controller Firmware
The AeroEgg Technology AET F405A WING flight controller currently supports ArduPilot and INAV fir...
Reference Materials and Appendices
Step-by-step AP firmware flight controller configuration tutorial (compiled by Piaopiao) https://...
Pin Mapping Overview
ArduPilot Pin Mapping INAV Pin Mapping
Power Supply Logic
Warning: Never exceed the rated power capacity. Abnormal overheating in flight may damage the fli...
Peripheral Connection Reference Diagrams
These diagrams are for reference only and apply only to ArduPilot firmware. Make all connections ...
Hardware Configuration
Detailed Hardware Specifications
Chapter 11: WS2812 Programmable LED Strip Connection and Configuration
Connect the WS2812 LED strip using three wires: GND, 4~7V, and IN. Terminate them in a 2.54 mm 3-...
Chapter 10: Adjusting Cruise Throttle
Users have reported that after the aircraft returns overhead during RTL, it may enter a high-spee...
Chapter 9: Connecting, Configuring, and Using the Airspeed Sensor
This example uses a Fapple airspeed sensor with the MS4525D protocol. Recommended wiring: use the...
Chapter 8: RSSI Setup
Common receivers include ELRS, TBS_CRSF, and SIYI receivers. SBUS receivers do not provide RSSI. ...
Chapter 7: Onboard Bluetooth Telemetry Connection
The AeroEgg AET H743 Basic flight controller includes an onboard Bluetooth telemetry module. You ...
Chapter 6: ESC Throttle Range Calibration
After assembly, calibrate the ESC throttle range while the ESC is connected to the flight control...
Chapter 5: Adjusting the OSD Layout
Open the OSD settings: CONFIG/TUNING -- Onboard OSD -- Screen1 ArduPilot OSD configuration is si...
Chapter 4: Full Parameter List
Most additional settings are configured individually in the "Full Parameter List", which is one o...
Chapter 3: Basic Configuration and Tuning
Section 1: Connect the Ground Station and Reset Default Parameters. Open the MissionPlanner confi...
Chapter 2: Flight Controller Wiring
The wiring diagram for the AeroEgg Technology AET H743 Basic flight controller is shown below: C...
Chapter 1: Firmware Flashing
Chapter 1: Flight Controller Firmware Flashing The AeroEgg AET H743 Basic flight controller curre...