Recently Updated Pages
OSD Layout Configuration
Open the OSD information settings. AGC OSD display configuration is similar to INAV configuration...
Full Parameter List
Most additional parameters are configured individually in the Full Parameter List. This level of ...
Flight Modes
Ardupilot uses one proportional channel to select among six flight modes. The default is radio tr...
Radio Transmitter Calibration
Flight Controller Calibration β Radio Calibration β Start Calibration Calibration Procedure If ...
Fixed-Wing Aircraft
U7 Flight Controller AGC Configuration and Tuning Guide 1. Confirm the Aircraft Type 2. Flash the...
Servo and ESC Configuration
Ardupilot firmware allows the flight controller S1~S12 outputs to be fully customized. In the fig...
Basic Configuration and Tuning
2.1. Section 1: Ground Station Connection and Resetting Default Parameters Download the AGC confi...
Flight Controller Wiring
2.1. AeroEgg AET H743 Basic Flight Controller Wiring Diagram Note the forward orientation of the...
DFU Mode Not Detected
Some computers may fail to detect DFU mode because of a driver issue. In Windows Device Manager, ...
Flashing Flight Controller Firmware (AP by Default)
Chapter 1: Flashing Flight Controller Firmware The AeroEgg Technology AET H743 Basic flight contr...
H743 Flight Controller Reference Images
This guide explains the ArduPilot configuration and tuning workflow for beginners and covers the ...
Industrial GPS-CAN Configuration Guide
Step 1: Physical Connections Ensure that the CAN GPS and CAN compass modules are correctly connec...
Wiring Diagrams and Wiring Instructions
The wiring diagrams for the AeroEgg AET H743 Basic flight controller are shown below: Common per...
MP Ground Station Displays Logging Failed
Set the LOG_BACKEND_TYPE parameter to 0 to clear the message.
Special Instructions for Using an SBUS Receiver with the AET-405A Flight Controller
F405 Flight Controller SBUS Wiring Instructions Interface Description SBUS uses the UART2 interfa...
Chapter 3: Basic Configuration and Tuning
Section 1: Ground Station Connection Open MissionPlanner. Connect the flight controller to the c...
Chapter 2: Flight Controller Interface Diagram (Wiring Instructions)
For an ELRS or TBS CRSF receiver, connection to UART4 on the flight controller is recommended. Co...
Chapter 1: Firmware Flashing
1: Firmware Download Firmware download URL: https://download.aeroeggtech.com/ Select: ArduPilot F...
AeroEgg Technology U7 Flight Controller Hardware Overview
Chapter 8: VTOL, Transition, and Fixed-Wing Testing
8. VTOL Testing 8.1 Multicopter Feedback Logic Check Complete the flight controller self-test and...