Skip to main content

AET-H743basic AGC Configuration and Tuning Guide

Thank you for choosing our product. We will continue to optimize and upgrade it in appreciation of your trust and support.

This tutorial is primarily written for the H743. F405 users only need to pay attention to the port configuration; all other content applies equally.

Preface

First, we sincerely thank you for choosing AeroEgg Technology and appreciate the trust and supp...

H743 Flight Controller Reference Images

This guide explains the ArduPilot configuration and tuning workflow for beginners and covers the ...

Flashing Flight Controller Firmware (AP by Default)

Chapter 1: Flashing Flight Controller Firmware The AeroEgg Technology AET H743 Basic flight contr...

DFU Mode Not Detected

Some computers may fail to detect DFU mode because of a driver issue. In Windows Device Manager, ...

Flight Controller Wiring

2.1. AeroEgg AET H743 Basic Flight Controller Wiring Diagram Note the forward orientation of the...

Basic Configuration and Tuning

2.1. Section 1: Ground Station Connection and Resetting Default Parameters Download the AGC confi...

Servo and ESC Configuration

Ardupilot firmware allows the flight controller S1~S12 outputs to be fully customized. In the fig...

Radio Transmitter Calibration

Flight Controller Calibration β€” Radio Calibration β€” Start Calibration Calibration Procedure If ...

Flight Modes

Ardupilot uses one proportional channel to select among six flight modes. The default is radio tr...

Full Parameter List

Most additional parameters are configured individually in the Full Parameter List. This level of ...

OSD Layout Configuration

Open the OSD information settings. AGC OSD display configuration is similar to INAV configuration...

Connecting via Onboard Bluetooth Telemetry

Power the flight controller from the battery before using onboard Bluetooth. The AeroEgg Technolo...

RSSI Setup

Commonly used receivers include ELRS, TBS_CRSF, and SIYI receivers. SBUS receivers do not provide...

Airspeed Sensor Connection and Configuration

This example uses a Fapple airspeed sensor with the MS4525D protocol. Refer to the airspeed senso...

Using and Configuring WS2812 Programmable LED Strips